FAQ
Can A10W be considered for use in electrical machining?
We believe A10W can be used safely even in electrical machining.
Fine particle grain cemented carbide inhibit crack propagation through mixing coarse-sized grain, and the heat affected layer's thickness is reduced through lowering the amount of Co. This is why we recommend A10W for wire EDM.
Q&A in the same category in this question
-
Which carbide material is the most resistant to abrasion?
The SS Grade carbide, made for abrasion resistance.
SS13 and SS15 have the hardness of HV2450 and HV2100, respectively.
These materials are not very tough, so it is recommended that you use them under a low load. -
高速プレスで寿命を延ばしたい
切り刃のラッピングをお薦めします。
面粗度を上げる事により滑りを良くし摩耗を緩和します。
弊社では異形状も砥石ラップを行う事で精度を保持したまま0.3S以下の面粗度を約束します。 -
We are using fine grain and ultra fine grain carbide parts with wire cutting and EDM machines, but chipping occurs often during use.
Try our A10W.
This material maintains the transverse rupture strength of KD20, while having resistance to thermal cracking during EDM/WEDM improved.
-
Catalog
We will provide high value-added cemented carbide with the achievements and know-how cultivated so far.
Download -
Consultation and Inquiry
We solve your problems by providing integrated solutions from material selection/development to precision machining and provision of finished products.
Contact us -
FAQ
We have posted the contents of many inquiries from customers in the past.
Click for details