We solve difficult problems with integrated support from carbide materials to finished product manufacturing!
FAQ
Can A10W be considered for use in electrical machining?
We believe A10W can be used safely even in electrical machining.
Fine particle grain cemented carbide inhibit crack propagation through mixing coarse-sized grain, and the heat affected layer's thickness is reduced through lowering the amount of Co. This is why we recommend A10W for wire EDM.
Q&A in the same category in this question
-
What about working with pure iron, pure copper, and nickel?
The reason for a shorter lifespan is due to their affinity with cobalt contained in carbide.
We have received great praise for our MC20 that controls this adhesion with lowered affinity to these materials. -
To extend die life of high-speed presses
Lapping of the cutting edge is recommended.
Raising the surface roughness improves sliding and mitigates wear.
-
Which carbide material is the most resistant to abrasion?
The SS Grade carbide, made for abrasion resistance.
SS13 and SS15 have the hardness of HV2450 and HV2100, respectively.
These materials are not very tough, so it is recommended that you use them under a low load.
-
Catalog
We will provide high value-added cemented carbide with the achievements and know-how cultivated so far.
Download -
Consultation and Inquiry
We solve your problems by providing integrated solutions from material selection/development to precision machining and provision of finished products.
Contact us -
FAQ
We have posted the contents of many inquiries from customers in the past.
Click for details